Inspector, Detail I

Determines and documents the modification status/configuration of products being processed for repair or overhaul to verify compliance to the applicable regulatory and customer requirements. • Ensures the products to be inspected are sufficiently clean and in acceptable condition to perform the inspections necessary to complete the work instruction. • Determines the repairability of those products not meeting the applicable requirements. • Records the inspection results on the appropriate inspection documentation. • Generates an estimate on the cost of replacement parts and labour necessary to complete the applicable work instructions. • Generates the applicable documentation for the repair of unserviceable products. • Inspects and identifies parts in the Reduced to Spares (RTS) process. • Supervises detail inspection trainees in the on-the-job training (OJT) process. • Participates in continuous improvement of cell processes. • Cross trains in other complementary skills and seeks endorsements for those skills as needed to support production requirements. • Moves between production assignments that utilize multiple skills as needed to support production requirements. • Participates in the cross training of other technicians as needed to support production requirements. • Responsible for observing all applicable safety requirements and reporting immediately any unsafe practices/conditions. • Carries out other duties as assigned. Relocation Provided: No Position Requirements: Knowledgeable and proficient in the proper use of precision measuring equipment. • Ability to read, understand and interpret blueprints. • Knowledgeable in and ability to identify and interpret conditions on products that are the result of service operation. • Ability to use and interpret publications used in the production process (graphs, charts, schematics, blueprints). • Working knowledge of the functions and operation of the products being inspected. • Proficient in technical writing. • Working knowledge of production management computer system and other related internal control systems. • Ability to complete the Detail Inspector Training & Development Plan. • Ability to lift up to 50 pounds (unassisted) for approximately 25% of the average work day. • Regularly required to sit for prolonged periods. • Previous inspection experience preferred. Job grade will be dependent on qualifications!